Limitations Of Use - TEUFELBERGER treeMOTION evo Mode D'emploi

pic. 16
required lengths. Insert shock cord.
2) Pass shock cord through base
material of harness. Tie stopper knot
in one end of the shock cord, leaving
approx. 1 cm looking out of the end
of the knot. Cut the other end.
3) Tie stopper knot in the other end
of the shock cord. In this way you can
customize your harness by installing
gear loops anywhere between two holes
of the base material of the back pad or the
leg loops.

5. LIMITATIONS OF USE

treeMOTION evo may not be used in fall
arrest situations. Slack in the climbing line
should be minimised at all times. There must
not be any chance of a free fall. „Free fall"
does, however, not mean e.g. slipping of
the user´s feet. Be aware of the potential
for pendulum swings and manage the risk.
1) Cut tubing to
pic. 17
pic. 18
Choose the connection of the harness to an
anchorage point at a level which will result in
the least total fall distance consistent with the
user' s ability to carry out work tasks.
Never carry out work with this product if, as
a result of your physical and mental condi-
tion, your safety might be compromised in
scenarios of normal use or in emergencies!
Repairs, modifications or additions to this
product, apart from the replacement of the
spare parts as described above, shall only
be made by the equipment manufacturer or
persons or entities authorized in writing by
the manufacturer.
6. TO BE OBSERVED PRIOR TO USE
Prior to using it, this product must be subject
to a visual inspection in order to verify
its integrity, readiness for use and proper
functioning.
Once the product has been subject to a fall,
its use must be discontinued immediately.
If the slightest doubt remains, the product
must be retired or may not be used again
until a competent person, having subjected
such product to the required testing and
inspections, has approved its further use
in writing.
It must be ensured that the recommen-
dations for use with other components
be complied with: lanyards shall meet EN
358 or EN 354 and any further PPE must
meet the harmonized standards under the
regime of regulation (EU) 2016/425. Anchor
points must withstand a static load of 12
kN according to EN 795:2012. WARNING:
When using a tree as the anchor point the
same loads may be applied to the tree. Pay
attention to the choice of an appropriate
anchor system! Ensure all neighbouring
RepLacement paRts
13