Whale Orca Auto 1300 Manuel D'installation Et D'utilisation page 2

1. INSTALLATION & USER INSTRUCTIONS
Thank you for purchasing this Whale® product. For over 40 years, Whale® has led the way in the
design and manufacture of freshwater and waste systems including: pumps, plumbing, faucets and
showers for low voltage applications. The company and its products have built a reputation for
quality, reliability and innovation backed up by excellent customer service. For information on our full
range of products visit www.whalepumps.com
2. SPECIFICATION
Product Code
Flow Capacity @ 13.6 V d.c.
Flow Capacity @ 1m head
Voltage
Recommended Fuse Size
Current Draw
Outlet Diameter
Materials
3. PRINCIPALS OF OPERATION
IC - Intelligent Control Technology
At the heart of every Whale® IC product lies innovative electronic control circuitry built in. This
sensor technology is built into Orca Auto 1300 and means no separate bilge switch is required.
Orca Auto 1300
The Orca Auto 1300 is an automatic submersible bilge pump for use in marine vessels. Output
capacity depends on installation and operating conditions.
4. TO THE USER
Read the following instructions carefully.
5. TO THE FITTER
Check that the product is suitable for the intended application, follow these installation instructions
and ensure all relevant personnel read the points listed below. Also ensure that these operating
instructions are passed on to the end user.
6. APPLICATION
Orca Auto 1300 is designed for installation in recreational marine vessels only and operated on 12V
d.c. (BE1482) or 24 V d.c. (BE1484) electrical supply only. If it is intended for use for any other
purpose or with any other liquid, it is the user's responsibility to ensure that the pump is suitable for
the intended use and, in particular, that the materials are fully compatible with the liquids to be used.
The Orca Auto 1300 is not recommended for domestic applications.
The Orca Auto is recommended to have a Duty Cycle of 60%
7. WARNINGS
• NOTE The outlet must not be mounted below the water line.
This pump is not suitable for pumping flammable liquids, diesel, chemicals
•
etc. Suitable for bilge water only.
NOTE: Bilge pump capacities may not be sufficient to prevent flooding from
•
2
INSTALLATION AND OPERATION MANUAL
Whale® Orca Auto 1300
BE1482(B)
1300 US GPH (82 ltrs/min)
1078 US GPH (68 ltrs/min)
12 V d.c.
7.5 Amp Automotive
5 Amps
1" (25mm) / 1 1/8" (28mm)
Pump body: ABS, Seals: Nitrile®, Impeller: Acetal
ENG
BE1484(B)
24 V d.c.
5 Amp Automotive
2.5 Amps