Fein ASCD12-100W4 Mode D'emploi page 23

OBJ_BUCH-0000000394-001.book Page 23 Friday, January 10, 2020 9:27 AM
Selecting the rotation direction (figure
11).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the rotation selector switch to right or left
rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Switching on and off (figure 12).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Danger of burning. The appli-
WARNING
cation tool can become hot
during operation. Allow the application tool
to cool down:
– after placing the power tool down
– prior to tool changing.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Apply the power tool to the nut or screw
only when switched off, as a rotating applica-
tion tool could slip off.
Hold the power tool perpendicular to the
screw at an angle of 90° when screwing in and
unscrewing.
If the power tool is applied inclined, the screw
head can be damaged and the force is not
transferred to the screw.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Fig. 11
Rotational direction switch
Fig. 12
1.
2.
en
23
On/Off switch