Cleaning & Maintenance - Nostalgia Kegorator KRS6000 Serie Manuel D'instruction

CLEANING & MAINTENANCE
Follow the steps below to clean the keg tap and hoses. (see illustration below)
1. Turn off CO 2 completely before
attempting to clean.
2. Remove the hose from the coupler and
carefully twist the dispenser faucet
off the top of the KEGORATOR™ .
3. Ensure that the dispenser handle is in the
down position before flushing the hose.
If this is not set correctly, water cannot
flow through. Hold the open end of the
hose under running water for 3-5 minutes,
while the beer dispenser faucet drains into the sink. This will clear any excess beer that is
trapped inside, helping to prevent any bacteria or mold that could accumulate inside.
4. In order to clean and remove any excess beer that may leak into the unit space inside
the door, remove the black rubber insulation and wipe with a wet towel as needed.
Follow the guidelines below to care for your KEGORATOR™ when not in use.
• Please adjust the temperature gauge to MIN in colder environments because this unit does
not self-defrost and ice may build up inside the unit. The temperature gauge is located on
the back side of the KEGORATOR™ inside the cut out area at the bottom to the lower left.
• Always rinse the beer line if you do not intend to use your KEGORATOR™ for a period
of time. First, turn off the CO 2 and dispense beer until it stops. This will
release pressure in the keg so that the coupler can safely be detached.
• To avoid permanent damage to the unit, never use sharp objects inside the KEGORATOR™ .
15
1 Detach beer line
2
Flush hose with water