Tapping The Beer Keg; How To Operate - Nostalgia Kegorator KRS6000 Serie Manuel D'instruction

TAPPING THE BEER KEG

(SINGLE VALVE-TYPE KEG)
Connect to the Connect to the Connect to
Connect to
Beer Line Tube Beer Line Tube CO2 Gas CO2 Gas
Line Tube Line Tube
Black pull handle Black pull handle
Keg Coupler Keg Coupler
fig. 1 fig. 2
fig. 4 fig. 5
Follow these steps below to tap the Beer Keg.
1. Make sure the black pull handle of the Keg Coupler is in the closed (up)
position before installing it on the keg (Fig. 1). Insert the Keg Coupler into
the locking neck of the Beer Keg and turn clockwise until it locks into
position (Fig. 2). This means that it is secured to the Beer Keg.
2. Make sure the Beer Tower Faucet is in the closed (handle pointing straight back) position
before connecting the Keg Coupler to the Keg (Fig. 3). To secure
the tank connection, pull the Keg Coupler handle out and push down until it locks into
position. Listen for the "click" of the pull handle when it shifts into the final downward
position (Fig. 4). This will open the beer and CO 2 gas valves. The Keg is now tapped.
3. Carefully tilt the Keg and rest the edge on the Keg Base Board on the
bottom of the Interior Cabinet. Slide the Beer Keg slowly, ensuring
that it is properly located (Fig. 5) and carefully close the door.

HOW TO OPERATE

Follow the steps below to dispense beer.
1. Make sure that the KEGORATOR™ is plugged in properly to
a 120V, 60Hz, 15 Amps grounded AC outlet.
2. Place the drip tray under the beer faucet to avoid messes from excess beer.
3. Open the beer faucet by pulling the tap towards you to dispense the beer. If for any reason
the beer does not come out of the tap, please refer to the Tapping the Beer Keg section.
4. Increase the pressure if the beer runs too slowly (see Regulator section).
5. Hold the glass steady at a 45° angle. When it is ²
glass. Proper foam should be a tight creamy head and the collar
on an average glass should be ¾" to 1" high, ideally.
13
Beer Keg Neck Beer Keg Neck
fig. 3
Beer Keg Beer Keg
Keg Support
Keg Support
full, straighten the
/ 3
Lift Upright Lift Upright