Parts & Assembly; Washers - Nostalgia Kegorator KRS6000 Serie Manuel D'instruction

PARTS & ASSEMBLY
Read assembly instructions carefully before installing the KEGORATOR™ . If still
unsure whether the KEGORATOR™ has been properly installed after assembly
is complete, it is recommended that you contact a qualified installer.
Allow the KEGORATOR™ to stand in an upright position for about 8 hours before turning on
the power. Once the unit is laid on its side, the coolant in the refrigeration unit is shifted.
The coolant in the refrigeration unit needs to stabilize before the power is turned on.

WASHERS

Most washers are already attached to the KEGORATOR™ . Extra washers are
included and are in a plastic bag. They are labeled below. Refer to parts
diagram and corresponding numbers to see where the washers belong.
#1 Bottom of
Coupler (outside) Coupler (middle)
(38mm)
#3 Coupler Washer
(18mm) Directional Washer
#19 CO 2 Line to
Regulator to Coupler (10mm)
(7mm)
#1 Bottom of
of Coupler (center)
(22mm)
#4 CO 2 Rubber #18 CO 2 Tank Band
#21 CO 2 Line
Washer (22mm)
#1 Bottom
(19mm)
#25 Beer Tap
6