Hoover WM AXI Mode D'emploi page 74

To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum one set for each
programme.
l
It is possible to modify the spin speed at
any time, without shifting the machine to
PAUSE.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the programme and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the vibration,
improves noise reduction and prolongs
the life of the washing machine.
DELAY START button
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Set the required programme.
- Press the button once to activate it
(0:00h appears on the display) and then
press it again to set a 30 minutes delay
(0:30h appears on the display). The
pre-set delay increases by 30 minutes
each time the button is pressed, until
h24 appears on the display, at which
point pressing the button again will reset
the delay start to zero.
- Confirm by pressing the START/PAUSE
button (the light on the display starts to
flash). The countdown will begin and
when it has finished the programme will
start automatically.
foaming. If the
the load be
l
It is possible to cancel the delay start by
pressing the ON/OFF button (for at least
3 seconds).
STEAM button
l
This button allows a specific treatment
to follow certain wash cycles (please
refer to the program table).
l
The steam function works by relaxing
creases in wet
result reduces the time needed to iron
these items.
l
The fibres
refreshed by removing bad smells.
l
Every program provides a dedicated
steam treatment in order to ensure the
max imum cleaning efficiency according
to the items fabric type and colour.
This option
before pressing the START/PAUSE
button.
OPTIONS button
This button allows
between three different options:
- PREWASHING
l
This option allows you to make a prewash
and it is particularly useful for heavily
soiled loads (can be used only on
some programmes as shown in the
table of programmes).
If the detergent Autodose system is
off, to make a prewash, you need to
pour the powder detergent directly
into the drum. In this case, it is
suggested to use only the 20% of the
quantity reported on the detergent
package.
74
garments and as a
are regenerated
must be selected
you to
and
choose