Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATIONS
At power-up, the unit performs a self-test. Next, LD1 to LD4 flash for 5 seconds indicating the current operating mode. The
operating mode can be changed at this time by keeping the 'Mode'- push button pressed until the flashing stops. Next, by
repeated pressing the 'Mode'- pushbutton the desired mode can be selected. Once the correct mode has been selected,
release the Mode push button. After 5 seconds the LED's start to flash again for 5 seconds after wich the selection is stored
in the memory. Consequently, LED 4 will light to indicate that the selected function has been memorised.
( O = OFF
= ON)
LD4 - LD3 - LD2 - LD1
O
O
O
Function 1
O
O
O
Function 2
O
O
Function 3
O
O
O
Function 4
O
O
Function 5
MODE
A short push toggles between 'ON' and 'OFF' (teleruptor-mode).
On / Off switch
Application: General lighting control, no dimming
A short push toggles between 'OFF' and the last set intensity. Continuous pushing adjusts
On/off switch with
intensity. Stops at both min. and max. intensity.
pushbutton dimmer
Application: General lighting control with dimming
As long as the button is pushed the intensity gradually increases to max. level. It remains
Slow ON dimmer
at max. until the button is released.
Application: Greenhouse, etc.
As long as the button is pushed the intensity remains at max. level. At release the intensity
Slow OFF dimmer
gradually decreases until the 'OFF'-state is reached.
Application: Child's bedroom, etc.
Push the button to gradually increase intensity until max. level.At release, intensity
Slow ON/OFF
gradually decreases until the 'OFF'-state is reached.
dimmer
Application: Pet breeding and farming (chickens, birds, etc)
DESCRIPTION
Functions
7
Publicité
Table des Matières
