Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe 1362018 Serie Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.
Installation Instructions
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The fittings must be mounted in an insulated manner
and with sound insulation.
• Mount the body in such a way, that the outlet faces
to the top and that the marking on the protective
cover is flush with the face of the tiling.
• Depth of fitting: 56 mm to 84 mm.
• Note: When installation is complete ensure that the
mixer is turned off!
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
Connections Rp 1/2:
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 34)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Dimensions (see page 32)
Flow diagram (see page 32)
free flow
Spare parts (see page 33)
Special accessories (order as an extra)
extension set 28 mm
#32698000 (see page 33)
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
cold right - hot left
English
Final assembly (see page 35)
Test certificate (see page 40)