Weekly Timer - Gree Versati III Mode D'emploi

2.2.7 Weekly Timer

[Operation Instructions]
1. At the function setting page, by touching "Weekly timer", it will go to the setting page as shown below.
2. At the "Weekly timer" setting page, as shown in the figure below, the weekly timer can be set to "On" or "Off".
3. At the "Weekly timer" setting page, by touching the desired day (Monday ~ Sunday) it will access to the
setting page of this option.
4. At the weekday setting page, it is able to set the timer to "Valid" or "Invalid". Also, it is able to set three timing
periods, each of which can be set to "Valid" or "Invalid".
5. Then, by touching the "Save" icon, this setting will be saved.
[Notes]
●Three periods can be set for each day. The start time should be earlier than the end time for each period,
otherwise this setting will be invalid. In the same way, the latter should be earlier than the former.
●When the weekly timer has been activated, the display panel will act based on the current mode and
temperature setting.
●Timer setting for the weekday
"Valid" it indicates this setting works only when "Weekly timer" has been activated, unaffected by the holiday
mode.
"Invalid" indicates this setting does not work even though the "Weekly timer" has been activated.
●It will be memorized upon power failure.
2.2.8 Holiday Release
[Operation Instructions]
At the function setting page, by touching "Holiday release", it will go to the corresponding setting page, where it
can be set to "On" or "Off".
[Notes]
●When this function has been activated, at the 'Weekly timer" setting page, some week day can be set to
"Holiday release". In this case, the setting of the "Weekly timer" at this day is invalid unless it has been manually
set to "Valid".
●It will be memorized upon power failure.
2.2.9 Disinfection
[Operation Instructions]
1.At the function setting page, access to "Disinfection" setting page.
2.At the "Disinfection" setting page, it can select the disinfection clock, disinfection temperature and disinfection
week and the corresponding setting page will pop up at the right side.
3.Then, this setting will be saved by touching the "Save" icon.
Operation Instructions for Versati III
8