Machine Settings And Programs; Maintenance; General Safety Rules; Machine Cleaning And Maintenance Routine - edenox DROP IN Manuel D'instructions

EN

4.3 MACHINE SETTINGS AND PROGRAMS

COOLING:
The evaporator is made of an expanded copper refrigeration pipe directly in the tray.
The condensing unit includes a hermetic compressor and an air condenser as its main elements.
The gas used in the cooling circuit is described in table 1, with a working pressure of
approximately 1.4 bars. The gas expansion at the entrance of the evaporator is carried out by
means of a capillary tube.
RECOMMENDED WORKING TEMPERATURE: described in table 1.
The use instructions of the digital thermostat are attached to this manual. However, WE DO
NOT RECOMMEND THE ADJUSTMENT OF THE THERMOSTAT BY UNQUALIFIED PERSONNEL.
Please, CONTACT YOUR DISTRIBUTOR TO HAVE THE NECESSARY ADJUSTMENTS CARRIED OUT.

5 MAINTENANCE

5.1 GENERAL SAFETY RULES

Remove the exterior plastic and any remaining adhesive covering the steel.
Clean carefully before using by following the specific instructions detailed later in this manual.
Before carrying out any operation on the machine, always consult this manual which gives the
correct procedures and contains valuable information on safety.

5.2 MACHINE CLEANING AND MAINTENANCE ROUTINE

Any technical maintenance must be carried out by your distributor's technical assistance
service.
Keeping the cooling unit clean, specifically the condenser is very important to optimize its
operation and reduce electricity consumption. Use soft brushes or a vacuum cleaner for this.
To clean the appliance, it is recommendable to firstly disconnect the same from the mains
electricity supply.
• Do not splash water on the electric components.
• To clean the stainless steel, use a sponge or cloth, tepid water and neutral soap.
• Do not use abrasive products, solvents, metal cleaning liquids or undiluted detergents.
• Dry with a cloth afterwards

5.3 MACHINE DISPOSAL

Instruction Manual
[17]