Hayward ColorLogic 320 LACUS11 Serie Manuel Du Propriétaire page 7

than 8 inches (20 cm) above the maximum pool or spa water level, or not less than 4 inches (10 cm)
above the ground, whichever is greater. Additional conduit should be run from the junction box to the
power supply, switch panel, pool/spa controller, etc.
Install Wiring using a Wallmount Transformer
A suitable transformer must be installed which is agency listed for low-voltage swimming pool and
spa lights (Hayward LTBUY11300, Intermatic model PX100/PX300, or equivalent). The transformer
®
must be rated at or above the total wattage used by all attached light fixtures. Up to 6 ColorLogic/
CrystaLogic 1.5" LED lights can be connected to a single Hayward LTBUY11300 transformer at the
14V tap.
Run conduit from the junction box to the low voltage transformer, pool/spa controller, or switch box.
Snake 2 wires through the conduit from the junction box to the power supply. If multiple lights are
being installed, run additional conduit/wires from the junction box to the additional junction box(es).
When wiring multiple lights to the same 12 volt source, do not exceed the transformers's total rated
wattage. Refer to the manufacturer's specifications and instructions for run length and wiring size.
Use wire nuts to connect the field-installed wiring to the light fixture cord in the junction box.
6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS