Introduction; Installation - Hayward ColorLogic 320 LACUS11 Serie Manuel Du Propriétaire

Congratulations on your purchase of a Hayward
Your Hayward ColorLogic and CrystaLogic 1.5" LED underwater light has these special features:
1. Long-lasting LED's (light-emitting diodes) which can last up to 10 times longer than current
incandescent or halogen pool and spa lights.
2. ColorLogic models have multi color capability without any color wheels or moving parts to wear
out.
3. In Universal ColorLogic mode, the ColorLogic 1.5" light allows you to select any one of 17 dif-
ferent programs, 10 fixed colors, and 7 color shows in stand-alone mode.
4. In Omni Direct mode (requires either an OmniHub or OmniLogic pool controller), the LYCU-
S11xxx and LACUS11xxx lights offer 27 different programs; 20 fixed colors and 7 color shows
with full control over speed and brightness.
5. When networked with a Hayward Pro Logic
LACUN11xxx and LYCUN11xxx light models are capable of 11 shows, 101 fixed light colors and
offer custom speed, brightness and motion control.
6. Offers spectacular brilliant light with low power consumption. Uses up to 86% less energy than
a typical incandescent pool light.
The 12 volt Hayward ColorLogic and CrystaLogic 1.5" LED (light-emitting diode) lighting fixtures
you have purchased are UL Listed and intended for use both in and out of water. Because of the all
plastic design with an impact resistant lens, these lights can be installed as little as 4 inches (10cm)
from below the normal water level of the pool or spa to the top of the lens. It can also be installed
upward facing on a floor without a rock guard for pools, spas,
Refer below for specific information about your 1.5" LED light model.
160 Models
LYWUS11xxx - white only, 100% brightness only
LYCUS11xxx - 100% brightness only
LYCUN11xxx - 100% brightness only, network support
320 Models
LAWUS11xxx - white only, selectable 50% or 100% brightness
LACUS11xxx - selectable 50% or 100% brightness
LACUN11xxx - selectable 50% or 100% brightness, network support
xxx - length of power cord
If replacing an existing light, remove power to the light at the panel before starting this installation.
Installation must be performed in accordance with Local and NEC codes.
Cord Length and Minimum Required Voltage
When installing ColorLogic/CrystaLogic 1.5" LED low voltage lights, the length of the cord has an
effect on performance. To prevent performance problems, verify the transformer is providing the
minimum required voltage according to the table below. To check this voltage, measure the voltage
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Introduction

ColorLogic
®
pool/spa controller (requires AQL-COLOR-MODHV),
®

Installation

or CrystaLogic 1.5" LED Light.
® TM
lighting ponds, fountains, or water falls.
2