Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 3 6x15 BTR screws
- 3 Ø6 washers
- 5
6 nuts
- 1 bracket
- 2 beleved spacers
Assembly
- Remove both saddles, the side panels as well as the rear light support and the original number plate
support.
- Replace the side panels and mark on the tool box the side panel outlines using a white pencil.
- Remove the side panels and cut the tool box at five mm over the line.
- Fix the rear light on the undertray and place the reinforcement bracket.
- Replace the side panels and fix the undertray using the two original plastic rivets.
- Replace both saddles.
- If necessary, fix the plate with the supplied beleved spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data
of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
* The "Ermax" mudguard and undertray are compatible.
FITTING INSTRUCTIONS
« CAUTION »
« UNDERTRAY »
TL 1000 R 1998/2003
Original tyre Metzeler in 190/50.
Publicité
