Care And Maintenance - Festo FDG Série Notice D'utilisation

FDG-...
In order to scan the slide positions:
S
use sensors with inductive switching principle together with ferritic switching
tags.
Due to the clean outer slide, the FDG does not possess magnets.
You can protect unused sensor grooves from dust deposits by using cover
rails.
6 Commissioning
If the emergency buffers are used:
S
Check to see if the support of the emergency buffer is displaced or is damaged
asymmetrically.
If this is the case, the support KYP-... must be positioned again.
When doing this, make sure that you tighten the clamping screws again.
S
Pull gently on the adhesive connection between the emergency buffer and the
support.
If the adhesive layer or the emergency buffer is damaged, you must replace the
emergency buffer completely.
7

Care and maintenance

S
Lubricate the slide bearing with roller grease KP2K (as per DIN 51825) on all
four lubrication nipples.
The grease cavities of the roller guide will only be filled equally if you push the
slide by hand, at the same time applying the grease.
To do this you will require a pressure grease gun with a pinpoint nozzle (see
"Accessories").
If used under heavy loading conditions, the slide bearing should be lubricated
after every 400 km.
20
Festo FDG-... 0101NH English