Festo FDG Série Notice D'utilisation page 16

FDG-...
5 Fitting
Mechanical
S
Compare the stroke h (Rated stroke) of your FDG with the drive axis assigned
(see specifications on type plate).
The stroke length h between the mechanical end positions can be calulated
from the length of the paths between the respective outer edge of the slide
system and the end position stop.
Rated stroke FDG
h [mm]
Stroke h
Fig. 5
S
Place the FDG horizontally on a level mounting surface (evenness of the
surface Rt 0.2 mm).
Axis fastening kits, centre supports and foot fastenings can be used here.
The adjacent diagram shows the distances between supports in relation to
rated size and loading.
By adhering to these specifications, you will avoid distortion and impairment
of both operation and service life.
16
Type plate specification
of the drive axis
L [mm]
h
h h
DGE-40-800-SP-KF-GK
h
³
Stroke L
The assignment
will only function
without a colli-
sion if the guide i if th id
axis has an equal
or longer stroke.
Festo FDG-... 0101NH English