Fdg - Festo FDG Série Notice D'utilisation

FDG-...

S
Tighten the fastening screws for diagonal
fastening at first only slightly
(see Fig. 7: Q).
This enables the FDG-... to be aligned
correctly before further fitting is under-
taken.
S
Position the FDG-... parallel to the driven
linear axis.
If you are using the FDG-... in conjunction with a drive axis type DGE-.. or
DGP(L)-...:
S
Make sure that the slide surfaces of both
axes lie at the same height within the
complete positioning stroke.
S
Place the diagonal connection and the
work load on the slides of the FDG-... and
the drive axis so that:
– The tilting torque of force F remains
parallel to the cylinder axis and dis-
tance d remains small.
Force F here contains the inertial force
F = m × a, force due to weight and any
external force.
– Loadings do not exceed the max. per-
mitted values.
In the case of guide axes with several slides
S
Compare the distance between the two
slides with the minimum distance as
shown in the adjacent diagram.
18
Fig. 9
Fig. 10
Fig. 11
F
Fig. 12
a
min
Fig. 13
Festo FDG-... 0101NH English
F