Step 5. Replacing The Access Cover; Installing The Range; Installing The Anti-Tip Device - Samsung NE63 8 Serie Manuel D'installation

Step 5. Replacing the access cover

To replace the rear access cover on the range back. Insert the double projections
on the bottom of the cover into the pockets located below the opening, and then
insert and tighten the rear access cover screw.
Install_NE63T8911_AA_DG68-01257A-00_EN.indd 13

Installing the range

Installing the anti-tip device

WARNING
To reduce the risk of tipping, you must secure the appliance by properly installing
the Anti-Tip device packed with the appliance.
• Refer to the installation instructions supplied with the bracket.
• If the anti-tip device is not installed properly, an adult or child stepping on or
sitting on the range door could tip the range and suffer serious injuries caused
by spilled hot liquids or by the range itself.
*approximately
21 ⁄ " (16.5 mm)
32
Screw must enter wood or concrete
NOTE
To install the Anti-Tip bracket, release the leveling leg. A minimum clearance of
21 ⁄ " (16.5 mm) is required between the range bottom and the kitchen floor.
32
Anti-Tip
bracket
English 13
3/19/2020 4:15:03 PM