Proper Usage; Interlock And Key - Chauvet DJ GigBAR IRC Manuel De L'utilisateur

Proper Usage

Interlock and
Key
GigBAR™ IRC User Manual Rev. 2
This product is for overhead mounting only. For safety purposes, Chauvet recommends
mounting lighting effect products on steady elevated platforms or sturdy overhead supports
using suitable hanging clamps. In all cases, use safety cables. Obtain appropriate mounting
hardware from your lighting vendor.
International laser safety regulations require that laser products must be operated in the fashion
illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and
the lowest laser light. Additionally, 3 meters of horizontal separation is required between laser
light and audience or other public spaces.
CAUTION! Use of controls, adjustments, or procedures other than THOSE specified IN
THIS USER MANUAL may result in hazardous radiation exposure.
· Chauvet requires the placement of sandbags on the base of the stand for added
stability.
· IMPORTANT: DO NOT go past the printed stopping point on the mast.
· DO NOT over-tighten the parbar, as it may damage the stand.
· DO NOT use this stand in any way that it was not intended.
This product has an interlock and key to prevent the laser from operating unless the interlock
and the key are both inserted and the key is turned to the ON position.
For the laser to function, you must BOTH:
·
insert the interlock
·
insert the key and turn it to the ON position
Otherwise, if both are not performed, the laser will not turn on.
Insert the
Interlock
Always turn the key to the OFF position and remove it when leaving this product
unattended to prevent accidents or injuries to third parties.
Insert and Turn
the Key to the
ON Position
ON
Page 17 of 96