Leggero Cuatro Manuel D'utilisation page 61

Assembly of Cuatro T
Place the chassis on a level surface after opening the packing and
checking the delivery. It is preferable that a table be used for this
purpose.
Assembly__________________________________________________
The hardtop is ready for travel when mounted on the chassis. The
1
clip closure on the tail can be opened and closed again with a short
jerking movement.
The wheels (E) provided can be easily mounted.
Use the M8x120 screws (H) and washers (I), along with the
wrench (J) provided for this purpose.
Tighten the screws (wheel) securely and check these periodically.
2
The draw bar (C) provided can now be easily inserted into the pre-fitted
draw bar holder. Ensure that the snap button engages audibly and close
the quick-action catch. (Illus. 1).
A retention rod (1) was fitted to facilitate effortless loading and un -
3
loading.
Insert this when in use in the opening intended for this purpose in the
tail (II) of the trailer.
The boundary belt should be secured in the pre-fitted
anchoring bracket to prevent the hood from toppling over. (Illus. 2).
Your Leggero® Cuatro T is now assembled and ready to travel. It can be
hitched to the bicycle with a suitable becco® coupling.
Assembly of Cuatro TT
Place the chassis on a level surface after opening the packing and
checking the delivery. It is preferable that a table be used for this
purpose.
Assembly__________________________________________________
Prepare the hood (D) as illustrated and open the Velcro fastener
1
in the tail for inserting the coated handle.
The clip closure on the tail can be opened and closed again with a short
jerking movement.
The wheels (E) provided can be easily mounted.
Use the M8x120 screws (H) and washers (I), along with the
wrench (J) provided for this purpose.
Tighten the screws (wheel) securely and check these periodically.
2 The draw bar (C) provided can now be easily inserted into the pre-fitted
draw bar holder. Ensure that the snap button engages audibly and close
the quick-action catch. (Illus. 1).
The boundary belt should be secured in the pre-fitted
3
anchoring bracket to prevent the hood from toppling over. (Illus. 2).
Your Leggero® Cuatro TT is now assembled and ready to travel. It can be
hitched to the bicycle with a suitable becco® coupling.