Leggero Cuatro Manuel D'utilisation page 55

Assembly of Cuatro I/II
Place the chassis on a level surface after opening the packing and
checking the delivery. It is preferable that a table be used for this
purpose.
Assembly__________________________________________________
Prepare the hood (J) as illustrated and open the zip fasteners. Then take
1
the roof arches (E) and insert them into the textile hoses readied on the
inside. The milled indentation on the roof arch tube must be at the top.
(Illus. 1).
Now push the ends of the roof arches into the roof connectors intended
2
for this purpose. They are located on the pre-mounted roof strut (C) and
tail struts (B). Allow the snap buttons to engage. Do not close the zip
fasteners on the hood yet!
Now take the chassis (G) and insert the seats (F) into the seat strips locat -
3
ed on the chassis floor. Then take the seat belt hooks (I) and loop into the
fixing angle (II), pulling them tight.
Check that the seat is firmly secured!
The forward seat strip position is equivalentcorresponds to the sea-
ting position of a child between the ages of 1-4 years. The rear seat
strip position corresponds to the seating position of a child between
the ages of 3-6 years.
The chassis and hood are now prepared and can be easily attached to
4
the pre-fitted hinge angles. Ensure that the snap buttons engage properly.
Use the M8x120 screws (N) and washers (O), along with the wrench (M)
provided for this purpose.
Tighten the screws (wheel) securely and check these periodically.
5 You now have the possibility to insert the bumper (A) through the holes
intended for this purpose with the tail opened. Listen to ensure that the
snap buttons engage correctly.
Take the pennant (I) provided and fit it to the left side of the bumper
6
with the bracket intended for this purpose.
The draw bar (D) provided can now be easily inserted into the pre-fitted
7
draw bar holder. Ensure that the snap button engages audibly and close
the quick-action catch. (Illus. 2).
Your Leggero® Cuatro I/II is now assembled and ready to travel. It can be
hitched to the bicycle with a suitable becco® coupling.