Scubapro XTENDER Mode D'emploi page 24

• Operating limits exceeded alarm.
If the diver descends below the usage limits for Xtender, an alarm is stored
indicating that operating limits were exceeded, and when viewing the
Logbook for that dive, the segments of the display will fl ash.
• ppO alarm (oxygen partial pressure).
2
If the excessive ppO
stored in the Logbook and is indicated by a fl ashing ppO
Resetting the history
You can delete the total number of dives and the total dive time stored in the
computer. (Resetting is not possible if the dive ended less than ten minutes ago,
if there is no information in memory, or if an EEPROM error has occurred.) On the
History screen, press the Lock button and the letters "CLEA" will be displayed. To
confi rm the deletion, hold down the Select button for about 5 seconds; the data will
be deleted, the total dives will reset to 0, and the total time to 0h00.
Dive profi le
The dive profi le shows you the depth recorded corresponding to each sampling
interval for a maximum of 30 dives. Once this limit has been reached, the oldest data
are overwritten. If there is not enough memory available to enter the data currently
being recorded, old data may be deleted even if 30 dives have not yet been stored.
Information is also shown for: FO
Nitrox icon.
When you access the Dive Profi le mode, it immediately shows the information for the
most recent dive profi le. Example: If the memory contains logbook information for
dives 1 to 13, the profi le for dive 13 will be displayed (Fig. 13).
24
alarm is activated, even momentarily, the alarm is
2
, number of the dive in the logbook sequence,
2
icon.
2