Scubapro XTENDER Mode D'emploi page 13

In order to set the oxygen fraction, access planning mode by pressing the "mode"
button and then the "lock" button. The fi rst value you will see is FO , and you can
2
change it using the "light/set" button. Each time you press the button the oxygen
fraction increases by 1%.
The initial value is 21% (air), and you can set values up to (99%), and then the
cycles goes back to 21. To make it easier to set this value, if you hold down the
"light/set" button, the values scroll by faster, pausing briefl y at 32% and 99%.
If you do not set any value, Xtender shows "- -" in the display area reserved for
FO , but if a value is entered, Xtender switches to Nitrox mode and the "NX"
2
icon activates.
Figure 6
When Xtender is in Nitrox mode and at a depth of more than 1.5 meters (5 feet), it
also indicates the oxygen partial pressure right above the "NX" icon.
13