Ducati Pro1 plus Manuel D'utilisation page 5

� 1. Power on: Press Power on button for 3 seconds.
� 2. Power off: Press Power off button for 3 seconds.
� 3. How to turn on/off light: After power on the e-scooter, press the power on/off
button for 1 second, front light is turned on. Press again to turn off.
� 4. Brake: e-brake+disc brake, when brake, the rear light will be flashing.
� 5. How to change speed?: After power on, default is the lower speed. Switch the speed
by quick pressing two times the power On/off button within 1 second.
� 6. Battery indicator
33v-36v
36v-37v
37v-38.5v
38.5v o superiore
Low voltage warning: the 1st battery bar flashing once voltage is lower than 33V, buzzer
warning for 6 times in the same time.
� 7. Low voltage warning mode: Under this mode, the speed limitness is 7Km/h.
� 8. Auto Cruise: Speed Cruise activated automatically after same speed for 10 seconds,
then you can release the speed controller; press brake controller or press again the speed
controller, scooter returns back to manual mode.
� 9. Speed Setting:
Level 1: up to 6 km/h
Level 2: up to 20 km/h
Level 3: up to 25 km/h
� 10. Auto Power off: After 10mins without any operation, it will be powered off automati-
cally.
One battery bar light
Two battery bar light
Three battery bar light
All battery bar light