Control Panel - Kuppersbusch ITE1370-1 Notice D'utilisation

18
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban

Control panel

Pilot light
1
ON/OFF switch
2
Temperature regulator (warmest)
3
Temperature indicator
4
Temperature regulator (coldest)
5
Fast Freezing light
6
Fast Freezing switch
7
Alarm light
8
Alarm reset switch
9
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/
OFF switch until the Pilot light and the Tem-
perature indicator switched off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators,
the current temperature setting flashes on
the Temperature indicator. It is possible to
modify the setting temperature only with
flashing indicator. To set a warmer temper-
ature, press warmest Temperature regula-
tor. To set a colder temperature, press
coldest Temperature regulator. The Tem-
1 2 3 4
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
5 6 7 8 9
perature indicator displays the newly selec-
ted temperature.
The newly selected-temperature will be
reached within 24 hours.
Temperature indicator
During normal functioning the Temperature
indicator shows the latest set temperature.
Fast freezing function
You can activate the Fast freezing function
by pressing the Fast freezing button.
The Fast freezing light will light up.
This function stops automatically after 52
hours.
It is possible to deactivate the function at
any time by pressing the Fast freezing but-
ton.
The Fast freezing light will switch off.
Excessive temperature alarm
In the event of an abnormal temperature
rise inside the freezer (e.g. power cut) Alarm
light will start to flash and a buzzer will
sound.
After the temperature has returned to nor-
mal, the Alarm light will continue to flash, al-
though the buzzer has stopped.
When the Alarm reset switch is pressed,
the warmest temperature reached in the
compartment flashes on the Temperature
indicator .
are recyclable.