Control Panel - Kuppersbusch IKE2380-1 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

16
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

Control panel

1
ON/OFF button
2
Display
3
Temperature warmer button
4
Temperature colder button
5
OK button
Display
1
Timer function
2
Intensive Cooling function
3
Drinks Chill function
4
Fast Freeze function
5
Child Lock function
6
Alarm indicator
7
Temperature indicator
Switching on
To switch on the appliance do these steps:
1. Connect the mains plug to the power
socket.
2. Press the ON/OFF button if the display
is off.
9) If a water connection is foreseen.
1
2
Functions
6
5
6
It is possible to change predefined sound of
buttons to a loudly one by pressing togeth-
er Functions button and Temperature cold-
er button for some seconds. Change is re-
versible.
1
2 3
4
3. The alarm buzzer could operate after
4. The temperature indicators show the
To select a different set temperature refer to
"Temperature regulation".
Switching off
To switch off the appliance do these steps:
1. Press the ON/OFF button for 5 sec-
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
are recyclable.
4
3
Functions button
5
6
7
few seconds.
To reset the alarm refer to "High tem-
perature alarm".
If "dEMo" appears on the Display, the
appliance is in demonstration mode: re-
fer to "WHAT TO DO IF..." paragraph.
set default temperature.
onds.

Publicité

Table des Matières
loading

Table des Matières