Fiorenzato F64E Manuel D'instructions page 5

EN - WARNINGS
• Read thoroughly and stick closely to the in-
structions and warnings .
• Before use, ensure that the mains voltage is
the same as the voltage indicated on the data
plate of the machine .
• Connect the grinder-doser only to 10 A sock-
ets that are effi ciently earthed .
• Always remove the plug from the socket be-
fore carrying out any maintenance or clean-
ing of the grinder-dosers .
• Singlephase models are supplied complete
with cable and plug for connection to the
socket .
• Any tampering with the grinder-doser or
connections not complying with the above
indications invalidate the manufacturer's
guarantee .
• Do not operate the grinder-doser without
coffee in the hopper .
• Never tamper with the machines in any way .
• For any intervention on the machines, al-
ways apply only to the authorized service
centre .
• Never pull the power cable to remove the
plug from the socket .
• Only use the grinder-doser for the purposes
it is meant for .
• Position the grinder-doser a minimum of 5
cm from walls so as to allow good ventila-
tion .
• Keep the grinder-doser away from sinks and
jets of water .
• Never leave the grinder-doser unguarded
when switched on .
• This grinder-doser is not to be used by peo-
ple with limited mental or physical abilities
or by children less than aged 8, or by peo-
ple lacking in the appropriate knowledge or
experience, unless properly supervised by
someone responsible for their safety .
• Children must be supervised to make sure
they don't play with the appliance .
• Cleaning and maintenance must not be done
by children without supervision .
• Never switch on the grinder-doser if it seems
to be faulty .
• Use only original accessories and parts .
• To avoid the danger of fi re, never cover the
grinder-doser .
• If the power cable is damaged, it must be
replaced by the manufacturer, its technical
department or a person with similar experi-
ence in order to avoid any risk .
• Unplug the grinder-doser from the mains
when not in use for a long period .
• Let the grinder-doser cool down before mov-
ing it .
• In the interest of safety, the grinder-doser
must always be considered connected and
live .
• Take care, as the grinding blades may con-
tinue rotating for a short while even after the
grinder-doser is switched off .
• Do not let liquids of any kind come into con-
tact with the internal or external parts of the
grinder-doser .
• Never put ground coffee in the hopper in-
tended only for coffee beans .
• Do not tamper with the grinder-doser .
• Do not touch the grinder-doser with damp or
wet hands or feet .
• The hopper must be fastened to the grinder-
dosers grinding system by means of the rel-
evant screw which must be inserted in the
threaded hole located on the upper grinding
blade holder and in the hole on the neck of
the hopper .
• Make sure that the coffee outlet is free from
any obstruction otherwise the appliance will
stop .
• The manufacturer cannot be held responsi-
ble for bodily injury or damage to property
if these regulations are not complied with .
• Operating temperature: -10°C +60°C
Storage temperature: -40°C +70°C
• USA & CANADA - duty cycle:
25s "ON" | 60s "OFF"
If the grinder-doser is to remain inactive for
a long period, clean it carefully, wash and
dry the hopper and leave it open.
ATTENTION: Moving parts.
5