Test Symbols; Appliance Description; Operation; Programming Unit - Elcalor SH 2020 Utilisation Et Installation

WARNING Burns
Never operate this appliance...
◦ if the distance from adjacent objects or other
flammable materials (e.g. furniture, textiles)
would be less than the minimum permissible
distance.
◦ in rooms where it is at risk of fire or explosion
as a result of chemicals, dust, gases or vapours.
Ventilate the room sufficiently before heating.
◦ in the direct proximity of pipes or receptacles
that carry or contain flammable or explosive
materials.
◦ if an appliance component is damaged, the ap-
pliance has fallen over or there is a fault.
WARNING Burns
◦ Never place any flammable, combustible or in-
sulating objects or materials on the appliance
or in direct proximity to it.
◦ Ensure that the air intake and discharge are
never blocked.
◦ Never place any objects between the appliance
and the wall.
CAUTION Burns
Parts of the appliance can get very hot and may
cause burns. Particular caution is advised when
children or vulnerable persons are present.
WARNING Overheating
To prevent the appliance from overheating, never
cover it with anything.
Material losses
◦ Ensure that the power cable is not touching the
appliance.
◦ Never stand on the appliance.
◦ Never operate the appliance in the open air.

2.3 Test symbols

See type plate on the appliance.

3. Appliance description

The appliance is a wall mounted electric direct heater
for areas such as workspaces, kitchens, bathrooms and
similar.
The quiet fan draws in the indoor air that is heated by
a bare wire heater element. The air then exits evenly
through the hot air channel and the air discharge grille
set into the bottom of the appliance.
When the set room temperature is reached, it is main-
tained by periodic heating.
Overheating protection
The appliance is equipped with a high limit safety cut-out
that switches the appliance off in case it overheats. Once
the cause of the fault has been eliminated, the appliance
restarts within a few minutes (cooling period).

4. Operation

1 Programming unit

2 ON/OFF switch
3 Air discharge
4.1 Programming unit
The appliance is operated using the programming unit
which is located at the top right of the appliance front.
3
1 Display

2 User interface

3 Silent mode indicator with 1000 W heating stage
4.1.1 User interface
Button Designation Description
"Standby" but- Switch on the programming unit;
ton Put programming unit and heating appli-
ance into standby mode
"OK" button Selection;
Confirm settings
"Menu" button Call up and exit menu
"+" button Call up menu items;
Change settings
"–" button Call up menu items;
Change settings
Operation
1
2
3
1
2
37