Unpacking And Checking Equipment; Supplied Accessories - Kenwood NX-5000 Série Guide De L'utilisateur

Ignition Sense Input Terminal
Pin No. Name
Yellow B
Microphone Jack
Pin No. Name
BLC
1
D+
2 SB
3 GND
PTT
4
TXD
5 ME
MIC
6
VBUS
HOOK
7
RXD
D-
8 DM
RF Antenna Terminal
50 K impedance
GPS Antenna Terminal
50 K impedance

UNPACKING AND CHECKING EQUIPMENT

Note:
The following unpacking instructions are for use by your KENWOOD dealer, an authorized
●
KENWOOD service facility, or the factory.
Carefully unpack the transceiver. We recommend that you identify the items listed
below before discarding the packing material. If any items are missing or have been
damaged during shipment, file a claim with the carrier immediately.

SUPPLIED ACCESSORIES

DC power cable (with fuses) ................................................................................................ 1
15 A fuse ......................................................................................................................... 2
●
Mounting bracket ................................................................................................................. 1
Screw set
5 x 16 mm self-tapping screw ......................................................................................... 4
●
M4 x 6 mm hex-headed screw with washer .................................................................... 4
●
Spring washer ................................................................................................................. 4
●
Flat washer ..................................................................................................................... 4
●
Microphone (with cable)
KMC-35 (NX-5700/ NX-5800 only) ................................................................................. 1
●
Microphone hanger (with 4 x 16 mm self-tapping screws) ................................................... 1
User Guide ........................................................................................................................... 1
6
I/O Description
I Ignition Sense Input
I/O Description
O Mic Backlight Control
I/O USB Serial Data Input/ Output
O DC Power (Switched B) Output
- Ground
I PTT
O PC Serial Data to Radio
- Mic Ground
I Mic Signal Input
I USB VBUS
I Hook
I PC Serial Data to Radio
I/O USB Serial Data Input/ Output
I/O Mic Data Detection
Specification
13.6 V ± 15 %
Specification
Output Impedance: 1 kK
USB 2.0
13.6 V ± 15 %
200 mA (Max)
Ground
Input Impedance: 47 kK
UART TTL (0 V to 5 V)
Ground
Input Impedance: 600 K
5 V/ 1 mA (Typ.)
Input Impedance: 1 kK
UART TTL (0 V to 5 V)
USB 2.0
High Impedance