Auto-Off; Setting The Temperature; Energy Saving - DeLonghi ECAM23210B/SB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Auto-off

Please note
The appliance is set to turn off automatically if
not used for 2 hours.
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours.
P button to enter the menu;
2. Turn the selection knob (fig. 8) until the
light comes on;
button to select the function;
4. Turn the selection knob until the lights corre-
sponding to the number of hours before the
appliance goes off automatically come on:
15 minutes
30 minutes
1 hour
2 hours
3 hours
button to confirm;
button to exit the menu.
Auto-off is programmed.

Setting the temperature

To modify the temperature (low, medium, high)
of the water used to make the coffee, proceed
as follows:
P button to enter the menu;
2. Turn the selection knob until the
comes on;
button;
4. Turn the selection knob until the lights corre-
sponding to the required temperature come
on:
LOW
MEDIUM
HIGH
button to confirm;
button to exit the menu.

Energy Saving

Use this function to enable or disable energy
saving mode. When activated, it reduces energy
consumption while the machine is on in com-
pliance with current European regulations.
P button to enter the menu;
2. Turn the selection knob until the light E co-
mes on.
deactivate, the energy saving mode;
When the function is active, the E light remains
on.
Please note!
A few seconds may elapse between energy sa-
ving mode and delivery of the first coffee as the
appliance must heat up again.
Setting water hardness
page 17.
Install filter
the section "Installing the filter" on page 17.
Replacing the filter
the section "Water softener filter" on page 17.
Default values (reset)
This resets all menu settings and programmed
quantities back to the default values.
P button to enter the menu;
2. Turn the selection knob until the
light
lights come on;
Statistics function
This displays statistics relating to the machine.
To display, proceed as follows:
P button to enter the menu;
2. Turn the selection knob until the
comes on;
4. When the selection knob is turned and the
corresponding light flashes, the following
information is displayed:
-
how many coffees have been made;
-
how many times the machine has been
descaled;
-
the total number of litres of water deli-
vered;
11
button. The OK light flashes.
button to activate, or
to
button to exit the menu.
button. The OK light flashes;
button to confirm and exit.
light
button;

Publicité

Table des Matières
loading

Table des Matières