Philips PT715 Mode D'emploi page 12

English
12
Problem
The shaver does
not shave as well
as it used to.
The shaver does
not work when I
press the on/off
button.
Water leaks from
the shaver after
cleaning.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Possible cause
The shaving heads are
damaged or worn.
Long hairs obstruct the
shaving heads.
You have not inserted the
shaving heads properly.
The temperature of the
shaver is too high. In this
case, the shaver does not
work.
You have not connected
the shaver to the mains. This
shaver can only be used
directly from the mains.
This is normal and not
dangerous.
Solution
Replace the shaving heads (see chapter
'Replacement').
Clean the shaving heads one by one (see section
'Cleaning the shaving unit with the cleaning brush'
in chapter 'Cleaning and maintenance').
Make sure that the projections of the shaving
heads fit exactly into the recesses (see
chapter 'Replacement').
As soon as the temperature of the shaver has
dropped sufficiently, you can switch on the shaver
again.
Put the small plug in the shaver, put the adapter in
the wall socket and press the on/off button again.
During rinsing some water may collect between
the power unit and the housing. After rinsing this
water flows out through the socket. The power unit
is completely watertight so water cannot reach the
electronic parts of the shaver. Your shaver continues
to be absolutely safe.