Yamaha RX-V620 Mode D'emploi page 21

Right
(U.S.A. model)
VD
V/CBL
ITOR
UT
COMPONENT VIDEO
MONITOR OUT
SUB
WOOFER
OUTPUT
Subwoofer
system
SUBWOOFER jack
When using a subwoofer with built-in amplifier,
including the YAMAHA Active Servo Processing
Subwoofer System, connect the input jack of the
subwoofer system to this jack. Low bass signals
distributed from the main, center and/or rear channels are
directed to this jack. (The cut-off frequency of this jack is
90 Hz.) The LFE (low-frequency effect) signals generated
when Dolby Digital or DTS is decoded are also directed
if they are assigned to this jack.
Notes
• Adjust the subwoofer volume according to the operating
instructions for the subwoofer. (Fine adjustment is possible
using this unit's output level control of the effect speakers.)
• Depending on the settings of "1 SPEAKER SET", "6 DOLBY
D. SET" and "7 DTS SET" on the SET MENU, some signals
may not be output from the SUBWOOFER jack.
Main speakers A
Left
SPEAKERS
+
– –
R
A
MAIN
B
VIDEO
CENTER
+
–
S VIDEO
+
– –
R
REAR
(SURROUND)
Right
Center speaker Rear speakers
Right
+
L
SWITCHED
100W MAX.
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 4 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER
+
CENTER : 6 MIN. /SPEAKER
L
REAR : 6 MIN. /SPEAKER
Left
CONNECTIONS
Main speakers B
Left
AC OUTLETS
TOTAL
MAIN A OR B: 8 MIN. /SPEAKER
A + B:16 MIN. /SPEAKER
CENTER : 8 MIN. /SPEAKER
REAR : 8 MIN. /SPEAKER
17