Installing A Memory Module - Fujitsu LIFEBOOK NH751 Mode D'emploi

Installing a Memory Module

1
Turn off power to your LIFEBOOK notebook and
remove any power adapter.
2
Make sure that all connector covers are closed.
3
Turn the LIFEBOOK notebook bottom side up,
with the front panel toward you.
4
Remove the screw at the front of the memory
upgrade module compartment. (Figure 37)
5
To remove the cover, tilt the front edge up, then
pull forward until the tabs on the cover are free.
6
Remove the memory upgrade module from the
static guarded sleeve.
7
Align the memory upgrade module with the
component side up. Align the connector edge of
the memory upgrade module with the connector
slot in the compartment. The connector will be
pointing toward the rear of the notebook.
8
Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly
down and into the connector until it lodges under
the retaining clip. You will hear a click when it is
properly in place. (Figure 38)
9
Replace the cover by hooking the tabs under the
rear edge of the compartment opening and tilting
down until flush with the bottom of your notebook.
Replace the screws.
Figure 37. Opening the Memory Compartment
Figure 38. Installing a Memory Upgrade Module
68 - Memory Upgrade Module