Using The Power Options; Using The Windows Mobility Center; Closing The Display Panel - Fujitsu LIFEBOOK NH751 Mode D'emploi

Masquer les pouces Voir aussi pour LIFEBOOK NH751:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• [Fn+F6]: Pressing repeatedly will lower the brightness of your display.
• [Fn+F7]: Pressing repeatedly will increase the brightness of the display.

Using the Power Options

To change the brightness using the Power Options utility, open the Control Panel and select either Large
icons or Small icons in the View by: Double-click Power Options. At the bottom of the window, drag
the brightness bar to the desired level. Note that the settings you make via this utility become permanent
until you decide to change them again.

Using the Windows Mobility Center

To change the brightness using the Windows Mobility Center, open the Control Panel and select either
Large icons or Small icons in the View by: Double-click Windows Mobility Center. In the Display
Brightness area, drag the brightness bar to the desired level..
A
LWAYS POWER OFF THE COMPUTER BEFORE TRANSPORTING OR PACKAGING IT
DOWN
I
T IS POSSIBLE THAT THE UNIT MAY NOT AUTOMATICALLY GO TO POWER OFF OR HIBERNATE MODE WHEN YOU
CLOSE THE LID
OTHER APPLICATION RUNNING ON THE COMPUTER
A
TTEMPTING TO TRANSPORT THE COMPUTER WHILE POWER IS ON MAY DAMAGE THE NOTEBOOK DUE TO SHOCK
OR OVERHEATING SINCE THE AIR VENTS MAY BE BLOCKED OR RESTRICTED
W
HEN USING
BATTERY POWER YOUR BRIGHTNESS SETTING IS SET TO APPROXIMATELY MID
T
HE HIGHER THE BRIGHTNESS
BATTERY WILL DISCHARGE
POSSIBLE

Closing the Display Panel

Holding the edge of your display panel, pull it forward until it is flush with the body of your LIFEBOOK
notebook.
,
WAIT UNTIL NO LIGHTS ARE ILLUMINATED IN THE STATUS INDICATOR PANEL
. T
HIS SITUATION MAY OCCUR DUE TO PRE
AC
POWER YOUR BRIGHTNESS SETTING IS SET TO ITS HIGHEST LEVEL BY DEFAULT
,
THE MORE POWER THE NOTEBOOK WILL CONSUME AND THE FASTER THE
. F
OR MAXIMUM BATTERY LIFE
.
36 - Display Panel
. A
-OS
BOOT PASSWORD SECURITY SETTINGS OR SOME
.
.
-
LEVEL BY DEFAULT
,
BE SURE THE BRIGHTNESS IS SET AS LOW AS
FTER SHUTTING THE SYSTEM
.
. W
HEN USING
.

Publicité

Chapitres

Table des Matières
loading

Table des Matières