RECARO C 6000 Instructions D'utilisation page 37

Warning:
The screws in the kit are micro-encapsulated and should never to be used more than once.
The micro-encapsulation will become ineffective if they are repeatedly used and the permanent
securing of the screw connection can no longer be guaranteed.
16. Now move the RECARO seat as far forward as possible.
17. Screw the four rear screws (3, 4) from the installation kit into the adapter (finger-tight only).
18. Now move the seat as far back as possible.
19. Screw the two front screws (2) into the seat adapter using the stipulated torque. (Torx adapter T30)
Torque: M8 screws: 25 Nm ± 2 Nm
20. Now move the seat as far forward as possible and tightly screw the four screws (3, 4) at the rear using
the stipulated torque. (T30 Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
Danger:
If the torque is not set correctly, the screws will work loose whilst you are driving.
In this case, the safety concept can no longer be ensured and the vehicle may no longer be used.
The screws must be tightened using the stipulated torque.
L
1
21. Fit the cover (1) to the seat adapter.
RECARO Automotive Seating
1 Seat adapter cover
Page 16