Setting Options For Improved Air Circulation; Height Adjustment - RELAXXNOW VTX200 Manuel

13. SETTING OPTIONS FOR IMPROVED AIR CIRCULATION

The fan has three functions which allow you to better adjust the air comfort and improve
the air circulation in the room.
1. Oscillation
To activate the oscillation function for wider wind distribution, press the oscillation button.
To switch this function off, press the oscillation button
The control of the oscillation can be carried out while the fan is operating.
This fan has an improved wide-angle vibration for better circulation.
2. Tilt
The fan must be switched off when you make this setting.
To adjust the fan head to a certain angle, hold the motor unit with one hand.
Grip the protective grill with the other hand and carefully tilt the head of the fan until it
reaches the desired angle. Do not tilt your head further back than intended.
This can damage the device.

3. Height Adjustment

The fan must be switched off when you make this adjustment.
To adjust the height of the fan, reach between the upper column (#9) and
the middle column (#13). Loosen the counter nut for the height adjustment (#14).
Extend or retract the center column (#13) to adjust the height of the fan. Once the fan is in
the desired position, tighten the lock nut (#14) for height adjustment.
Converting to a Table Fan
The fan must be switched off when you make this conversion.
Loosen the upper column button (#11). Remove the complete upper column (#9) together
with the motor unit (#8). Then remove the lower column (#15) from the base by turning it
counterclockwise. Then remove the adapter (#16) from the lower column (#15). Now insert
the individual adapter (#16) into the base (#17) and secure it by turning it clockwise. Now
place the complete upper column (#9) together with the motor unit (#8) on the adapter
(#16). Turn the upper column button (#11) firmly to secure the device.
again.
RELA
EN
43
NOW