Charging Procedure - Worx WA3869 Mode D'emploi

away from inflammable materials. Batteries can
get hot during charging. Do not overcharge any
batteries. Ensure that batteries and chargers are
not left unsupervised during charging.
16. Do not recharge non-rechargeable batteries, as
they can overheat and break.
17 . Longer life and better performance can be
obtained if the battery pack is charged when the
air temperature is between 18°C and 24°C. Do
not charge the battery pack in air temperatures
below 4.5°C, or above 40.5°C. This is important
as it can prevent serious damage to the battery
pack.
18. Charge only battery pack of the same
model provided by WORX and of models
recommended by WORX
SYMBOLS
Read the operator's manual
Warning
For indoor use only
Double insulation
2
Fuse
Positive terminal
Negative terminal
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
Battery charger

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
The charger is designed to charge two battery packs
at the same time as well as charge one by one.
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or battery
pack connections because an electrical failure and
hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide one battery pack or two battery packs
into the charger. Normally, the relevant charge
indicator light (3) will flash in green color
showing the battery is being charged.
3) This is a dual-port charger and it has 2 charging
modes, Dual-Charging (default) and 1-by-1
charging.
a) ( )Dual-charging mode, for 2 battery packs
completed charging at the same time,
the charger charges both battery packs
simultaneously.
b) ( )1-by-1 charging mode, for reducing waiting
time to complete 1 battery pack charging
first. The charger charges the higher residual
capacity battery pack first until fully charged
then the charger charges another battery.
4) The 2 charging modes can be selected by
pressing Charging mode selector (4).
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
5
EN