Table des Matières
Publicité
FRAMER'S
1. Squaring Arm
Right angle back stop necessary to hold material square to Cutting Bar.
2. Cutting Bar
Heavy-duty extruded Cutting Bar with teflon coating and polished
surface.
3. Cutting Board
3/4" thick laminate surface Cutting Board.
4. Top Support Arm
Heavy-duty hinged aluminum arm provides support for Cutting Bar and
Handle Bar.
5. Handle Bar
Square shaped handle used to raise Cutting Bar to vertical position.
6. Bottom Production Stop
Production Stop tightens to the Cutting Bar Rod and stops the cutting
head at the location determined by the scale setting.
7. Bottom Support Arm
Heavy-duty hinged aluminum arm provides support for Cutting Bar and
Handle Bar.
8. Cutting Bar Scale
With dual inch/metric scale recessed into cutting bar to be used
together with the bottom production stop.
9. Squaring Arm Stop
Aluminum stop that slides onto either end of the Squaring A rm and
tightens into position.
10. Mat Guide
Movable, parallel guide bar used to set border width of the mat being
cut.
11. Cutting Head
Mounting block that glides on cutting bar and contains both bevel and
straight cutting blade holders.
2
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
EDGE
M AT C U T T E R MODELS 650, 655 & 660
12. Bevel Cutter Holder
45 Degree Bevel Blade Holder.
13. Straight Cut Blade Holder
90 Degree straight cut blade holder with lock-down pin.
14. Movable Production Stop
Movable stop which connects to cutting head. Allows fast production
cutting of mat board.
15. 8-Ply Setting
Adjustment screw used to set bevel cutting head to cut 8-ply thickness
matboard. Only the #268 blade will cut effectively at this setting.
16. Indicator Plate
Metal outrigger with green and red dot used to accurately start and
stop on marked lines resulting in minimal overcuts.
17. Blade Holding Screw
Easy grip blade screw for tightening blade on both straight and bevel
blade holders.
18. Bevel Cutter Blade Depth Adjustment
For adjusting the depth of the blade on the bevel side of the cutting
head.
19. Straight Cutter Blade Depth Adjustment
For adjusting the depth of the blade on the straight side of the cutting
head.
20. Lock-Down Pin
Pin for locking Straight Cutting Blade Holder in a down position so that
no downward pressure is needed when straight cutting.
21. Bottom Overcut Adjustment
For adjusting overcut at the bottom of the mat.
22. Top Overcut Adjustment
For adjusting overcut at the top of the mat.
23. Blades (Fig. 1, pg. 5)
#269 double bevel blade used for cutting standard thickness matboard.
#268 single bevel blade used for cutting 8-ply double thick matboard.
Publicité
Table des Matières
