Chopin SDmatic Mode D'emploi page 60

GB
SDmatic
❏ Place the reaction bowl in the SDmatic and fold down the arm.
❏ In order to speed up the test cycle, a testing solution could be
prepared in the second reaction bowl and could be preheated in the
SDmatic (this would reduce the heating time in the SDmatic during
the test).
Install the second reaction bowl to be preheated in the dedicated
place on the right-hand side of the SDmatic.
Note :
Do not leave the reaction bowl in this place for more than half an
hour: the temperature could become higher than 35°C and the
solution could evaporate.
The preheating should be used only in case of test series.
Installation of the reaction bowl Preheating place
❏ The bowls are fragile.
Handle the bowls with care when putting them in position.
User's manual
60
12/2016