Electrical Warnings - IKEA LAGAN Mode D'emploi

Masquer les pouces Voir aussi pour LAGAN:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
and in a place suitable for its size
and use. Make sure the appliance
is not near a heat source and
that the four feet are stable and
resting on the floor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant circuit
is fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning
or fixing of the appliance must
be done in accordance with the
manufacturer instructions. It's
forbidden to place the refrigerator
in such way that the metal hose
of gas stove, metal gas or water
pipes, or electrical wires are in
contact with the refrigerator back
wall (condenser coil).
To guarantee adequate
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear of
the appliance and the wall behind
the appliance should be 50 mm,
to avoid access to hot surfaces.
A reduction of this space will
increase the Energy consumption
of product. Please remove the
power cord from condenser
hook during installation before
connecting product to power
supply.

ELECTRICAL WARNINGS

It must be possible to
disconnect the appliance from the
power supply by unplugging it if
plug is accessible, or by a multi-
pole switch installed upstream of
the socket in accordance with the
wiring rules and the appliance
must be earthed in conformity
with national electrical safety
standards.
Do not use extension leads,
multiple sockets or adapters.
The electrical components must
not be accessible to the user
after installation. Do not use the
appliance when you are wet or
barefoot. Do not operate this
appliance if it has a damaged
power cable or plug, if it is not
working properly, or if it has been
damaged or dropped.
If the supply cord is damaged,
it must be replaced with an
identical one by the manufacturer,
its service agent or similarly
qualified persons in order to avoid
a hazard - risk of electric shock.
WARNING: Do not locate
multiple portable socket-outlets
or portable power supplies at the
rear of the appliance.
Feets of the product: in Fs not
available;in built in - the "feet are
not adjustable - and the METOD
cabinet should be levelled with
spirit level.
9

Publicité

Table des Matières
loading

Table des Matières