Use Rain Cover; Care And Maintenance - Joie litetrax 3 Manuel D'utilisateur

Use Rain Cover

To assemble the rain cover, place it over the stroller, and then attach the 8 pairs of hook and loop fasteners on the
rain cover.
28
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant car seat has been fastened.
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
Use with Car Seat
see images -
29 35
Use this car seat adapter only with the Litetrax Stroller and approved Joie Gemm and Nuna Pipa car seats.
! If you have any problems about using the car seat, please refer to their own instruction manuals.
! Please do not fold the stroller when the car seat is still attached.

Care and Maintenance

!
Removable seat pad may be washed in cold water and drip-dried. No bleach.
!
To clean stroller frame, use only household soap and warm water. No bleach or detergent.
!
From time to time, check your stroller for loose screws, worn parts,torn material or stitching. Replace or repair
the parts as needed.
! Excessive exposure to sun or heat could cause fading or warping of parts.
! If stroller becomes wet, open hood and allow to dry thoroughly before storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get the
oil into the axle and wheel assembly.
24
! When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
15
Note