Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Place the unit on a flat and stable work surface.
2.
Be sure unit is fully Cleaned and Assembled (see Assembly Instructions and
Cleaning Instructions).
3.
Do not operate the appliance continuously for more than 10 minutes, if you
do operate longer allow the appliance to cool for 30 minutes before second
operation.
4.
Make sure the Switch is in the "OFF or UP" position. Always reach switch
by entering from the back of the unit, keeping hands away from blade.
5.
Insert plug into standard 120 Volt electrical outlet, rated 15A minimum.
6.
Slide the Food Tray backward until it locks or slide out to remove and place
on supporting surface.
7.
Place food on Food Carriage, between the Support Plate and Slicing Guard. To
avoid risk of injury, always use Food Carriage and Slicing Guard while cutting.
8.
Set the Thickness Adjustment Knob to the desired thickness to be sliced.
9.
Start the Motor Assembly by sliding the Safety Lock and pressing the ON/
OFF button. The safety lock prevents accidental engagement.
10. Grasp the Slicing Guard with one hand and gently push food into Support
Plate while sliding Food Carriage towards Blade. When food has cleared
Blade slide Food Carriage back to starting position. IMPORTANT - NEVER
PUT YOUR FINGERS INTO THE BLADE WHILE UNIT IS OPERATING
OR PLUGGED INTO ELECTRICAL OUTLET.
11. To avoid injury wait until the blade has stopped moving before cleaning.
12. When you have finished slicing food, press Switch to "OFF or UP", unplug
from electrical outlet and follow cleaning instructions.
13. For safety, return the Blade Guard over the Blade and adjust slicer thickness
to "0" setting to protect Blade edge.
1.
Unplug cord from wall outlet.
2.
NEVER immerse the Motor Assembly in water or other liquid.
3.
All parts, except Motor Assembly are dishwasher safe. Always use care when
handling the Blade while cleaning.
4.
Remove Motor Assembly, instructions on page 4.
5.
Clean outer surfaces of Motor Assembly with damp cloth. Do not use steel
wool, abrasive cleaners or sharp utensils.
6.
After cleaning and drying all parts, replace all parts in reverse order of
removal, follow ASSEMBLY INSTRUCTIONS.
OPERATING INSTRUCTIONS
CLEANING INSTRUCTIONS
5
Publicité
Table des Matières
