Features; Before First Use; Operation; Care And Cleaning Instructions - Nesco FS-10 Manuel D'instructions

FEATURES

SUPPORT
PLATE
SLICING GUARD
THICKNESS
CONTROL THICKNESS
SCALE

BEFORE FIRST USE

1� Read and understand all instructions and components described in this manual� Keep for
future reference�
2� Remove all packaging and save for storage�
3� Remove and wash the Blade and Slicing Guard in warm soapy water� (follow Care and
Cleaning Instructions)�
4� Wipe the Base with a damp cloth� DO NOT IMMERSE THE BASE IN WATER OR ANY
OTHER LIQUID! (follow Care and Cleaning Instructions)�

OPERATION

1� Place appliance on a flat, dry and stable surface.
2� Be sure power switch is 'OFF', then plug into a standard 120V AC electrical outlet�
3� Place a suitable tray or plate behind slicer to collect the sliced food�
4� Place food onto food carriage between support plate and slicing guard� To avoid danger of
injury, always use food carriage and slicing guard while cutting�
5� Adjust the slice thickness by turning the thickness control to desired thickness from Deli
thin to 7/8" thick (0 - 23 mm)�
6� Slide food carriage back so food is clear of blade� Press power switch to start the slicer�
Keep left hand clear, place near the power switch, and grasp the slicing guard with the
right hand�
7� To begin slicing, push food in towards support plate while holding the slicing guard and
slide food into blade� Slide food carriage back and repeat until you have sliced the desired
amount of food�
8� When finished, press power switch to turn OFF unit. Note: Blade will continue to move
for a short time� Always keep hands away from moving blade! Remove plug from
electrical outlet before cleaning�
9� For safety, always return thickness control to '0' after use to shield sharp edge of blade
during storage�
BLADE LOCKING
BLADE
SCREW
FOOD
CARRIAGE
POWER
SWITCH
BASE
2

CARE AND CLEANING INSTRUCTIONS

1. Always unplug the appliance from electrical outlet before cleaning.
2� Never immerse the base of this appliance in water or other liquid�
3� The blade can be removed and hand washed in warm soapy water� Be careful when
cleaning the blade, as it is extremely sharp� Do not leave blade under water, trying to
handle sharp objects in water can be hazardous�
4� Set thickness control to "0"� This will keep the blade edge covered by support plate�
5� Remove blade by holding the blade with one hand and using flat edge screwdriver or
edge of a quarter to pinch and turn blade locking screw� Unlock blade by turning screw
clockwise� Carefully remove blade and hold by using the blade locking screw�
6� Clean outer surfaces with a damp cloth� Mild detergent or plain water can be used to
dampen cloth� Never immerse base in water or any other liquid� Do not use steel wool,
abrasive cleaners or sharp utensils to clean any part of this appliance�
7� After cleaning and drying, install blade to base in reverse order of Step 6� Carefully place
blade on mating hub of motor� Align the locking screw tabs with the mating slots in the
hub of motor and press in until seated� Rotate locking screw counter-clockwise until
seated to lock blade in place�
8� Store in a cool and dry area,
BLADE REMOVAL
3