General Safety Instructions; Special Safety Instructions For This Device - Clatronic HTD 2939 Mode D'emploi

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fi t for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
• The device and the mains lead have to be checked regularly
for signs of damage. If damage is found the device must not
be used.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
• This device is not intended to be used by individuals (includ-
ing children) who have restricted physical, sensory or mental
abilities and/or insuffi cient knowledge and/or experience, un-
less they are supervised by an individual who is responsible
for their safety or have received instructions on how to use
the device.
• Children should be supervised at all times in order to ensure
that they do not play with the device.

Special safety instructions for this device

Symbols on the Product
On the products you will fi nd symbols that indicate warnings or
provide information:
WARNING OF ELECTRIC SHOCK!
Do not use this device near baths, wash basins or
other vessels containing water.
05-HTD 2939 Neu.indd 17 05-HTD 2939 Neu.indd 17
• Warning: The nozzles become hot during operation.
• Do not use the device without the cover and the fi lter on the
suction intake!
• If the hair dryer is used in the bathroom, remove the mains
plug after use as water represents a hazard. This also ap-
plies when the hair dryer is switched off.
• Do not put objects, hair or your hands in front of the air
intake opening! The device can suffer damage despite the
overheating protection if the airfl ow is blocked!
• Please ensure that the inlet grille remains free of fl uff and
hairs. Danger of fi re!
• As additional protection we recommend the installation of a
fault current protection device (RCD) with a rated current of
not more than 30 mA in the wiring system of the bathroom.
Please contact an authorised electrician for advice.
Commissioning
1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the
mains voltage match.
3. Fit on a nozzle. You can dry single hair locks by concentrat-
ing the fl ow of hot air with the hairdressing nozzle. The
diffuser is the ideal solution to dry curly hair without losing
volume.
4. Insert the plug into a duly installed 230 V/50 Hz protective
contact socket.
5. Shift the switch on the handle to one of the desired heat/
blowing levels:
Level 0: off
Level 1: medium airfl ow and medium temperature
Level 2: strong airfl ow and high temperature
COOL-Shot: With this switch it is possible to interrupt
the heating process so that the air can be
mixed according to individual requirements.
Switch-off
After use shift the switch to position „0" and pull out the plug.
Leave the device to cool before putting it away! To this purpose
place the device on one side of the housing or hang it up by the
suspension lug.
Cleaning and care
• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
• The device must never be immersed in water!
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this
may result in the cable breaking.
• Check the mains cable regularly for damage.
Removing the air suction cover
Remove the cover after turning the cap through approximately
30 degrees counter clockwise direction. Remove the intake
fi lter and clean under running water. Dry the fi lter well before
mounting again!
17
15.12.2008 10:37:07 Uhr 15.12.2008 10:37:07 Uhr