John Bean B 1200P Manuel D'utilisation page 80

2
80
1
5-42
1
2
3
4
5
5-43
Operation "NO SPOKES"
5.6 SPOKES OFF AUTOMATIC
Mode
The Spokes Off Automatic Mode has the same features
as the Automatic function already described
except that it excludes automatic rim spoke detection.
When it is established that no information about spokes
is needed, in-depth spoke detection by the laser can
be switched off.
This noticeably reduces the overall measuring run time.
This function is retrieved with the key (2) available in
the Main menu. The change in the colour of the text
at the side of the symbol shows when the selection
is active.
After the measuring run the condition is identifi ed by
the pair of symbols (1, Fig. 5-42);
- Automatic "Profi ling"
- Rim with question mark
To enter the number of spokes manually, when the
measuring run has ended, switch to Manual Mode
using the sequence of keys;
•
"Home" (1, Fig. 5-43).
•
Manual Mode (2).
When you get to the Manual Balancing screen page,
•
"Home" (3)
•
"Balancing" (4)
•
Press key (5); each press increases the number of
spokes set by one.
Keep going until you reach the number of spokes on
the rim being processed.
In example: 5 spokes.
F
5.5,