Adjustments; Operation - Bosch GTA3800 Mode D'emploi

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 12
WoRk HEIGHT SUppoRT ADjUSTMENT
1. Loosen the locking knob located at the end
of the expansion rail, as shown in figure N,
and raise the work height support so it is
level with the table top of the attached
miter saw.
2. Retighten knob and repeat on opposite
side.
USING THE EXTENSIoN RAILS
See Figure P.
Use the extension rails when working with
larger workpieces.
FIG. P
FIG. N
EXTENSION
DJUSTMENT
KNOB
REpETITIvE STop ADjUSTMENT
To raise the repetitive stop: Lift up and in
place as shown in figure O.
To stow: Push the repetitive stop in toward
the rail assembly and down.
Repeat on opposite side.
LOCK
KNOB
To extend the rails:
1. Loosen the extension adjustment knob.
2. Extend the rail to the desired position.
3. Tighten the extension adjustment knob.
-12-
FIG. O