afriso Unitel Notice Technique page 37

5 Mounting
5.1 Mounting the product
 Verify that the product is accessible and easy to oversee at all times.
 Verify that the product is protected against water and splash water.
 Verify that the product is not mounted in a humid room.
 Verify that the permissible ambient temperature is not exceeded at the
product.
 Verify that the product is protected from direct sunlight.
1. Drill a hole into the wall.
2. Fit the enclosed dowel into the hole.
3. Screw in the screw up to approx. 1.5 cm.
4. Fit the product onto the screw and slightly pull it down.
- The lug is flush with the wall.
5. Create a mark at the wall through the hole of the lower lug.
6. Remove the product.
7. Drill a hole at the mark.
8. Fit the enclosed dowel into the hole.
9. Fit the product onto the screw again and slightly pull it down.
- The lug is flush with the wall.
10.Fasten the product to the wall by means of the second screw.
Mounting
1
EN
12
Unitel