Operation - Klarstein MAXFLOW SMART Mode D'emploi

EN
20

OPERATION

Switching on the device / switching to standby
As soon as the power supply is connected, the STANDBY indicator lights up and a short
beep sounds. The light flashes alternately dark-light-dark-light. The unit is now in standby
mode.
• Touch the STANDBY key to switch the unit on. The indicator light goes out and the
display in the center shows the ambient temperature. The unit enters the operating
mode. The air is blown out at low speed. The SPEED indicator lights up green.
• Touch the STANDBY key again to turn the unit off. The unit stops working
immediately, leaving the blink of WI-FI and STANDBY.
Setting the speed
Turn the unit on and press the SPEED key several times to set the speed to high >
medium > low. The indicator light will illuminate as follows:
• High speed: red light
• Medium speed: blue light
• Low speed: green light
Setting the timer
Turn the unit on, press the TIMER button several times to set the desired time from 1-12
hours. The SPEED indicator lights up and the display shows the set hours. Each press of
the button increases the time by 1 hour. Once the timer is set, the SPEED indicator will
remain lit and the display will show the ambient temperature.
• Briefly press the TIMER key to check the timer setting. Within 5 seconds, briefly
press the TIMER key again to reset the hours.
• Long press the TIMER key to clear the timer setting. The TIMER display goes out.