Start And Operation - Klarstein SKYSCRAPER ICE Mode D'emploi

EN
18

START AND OPERATION

Carefully remove all p ckaging materials and retain for future storage/use. Make sure
there is no residual foam left in any of the components. No tools will be required to
assemble this tower evaporative cooler.
Filling the Water Tank
• Locate the water tank knob
and turn it counterclockwise
90° to unlock the tank. Pull
out the tank from the back of
the cooler.
• Fill the tank with clean water.
Pay attention to the water
level indicator located on the
front of the cooler to avoid
overfilling the evaporative
cooler. Do not fill the tank
above the MAX water level
line or below the MIN water
level line. The approximate
tank size of the unit is 6 liters.
• Push the water tank back into
the rear o the unit and turn the
water tank knob clockwise
90° to lock the water tank
back into place.
Using the Ice Pack
• The tower evaporative cooler includes
an optional ice pack for added
cooling.
• There is an indentation at the bottom
of the tank that allows the pad to be
placed on its long/narrow side, like
shown in the picture.
• Alternatively, the pad can just simply
be put into the watertank without any
problem.