Maintenance - Boxis AutoShred Manuel De L'utilisateur

Operation (cont'd)
Overload Mode:
When the shredder overloads during shredding, the motor will stop. The LED will light
Overload. Pressing the Reverse button will start the motor reversing. Remove the
overloaded paper and continue in Reverse mode for 3 seconds to clear any remaining
paper particles.
• If user cannot remove the paper from the slot by pressing the Reverse button, tear off
the remaining paper and press Forward button to start shredding again and clean out
the paper. Repeat the above process until the paper is completely removed.
• If a paper jam occurs, press and hold the "Reverse" button to back paper out of the
paper entry. Try gently pulling on the paper to remove it from the shredder. Alternate
between forward and reverse, as needed, until the jam clears.
Door Open Mode:
When the wastebasket is opened while shredding, the motor will stop immediately. The
LED will light Door Open. To resume normal function, the door must be closed. The LED
will light Power again.
Overheat Mode:
If the shredder overheats, the LED will light Overheat. All functions will stop. When the
shredder overheats, user may press Stop button to place the shredder in Stand by mode.
The shredder will not resume normal functioning until the temperature of the motor cools
down to a safe temperature and LED will light Power.
Bin Full Mode:
If the wastebasket is full, the motor will stop and the LED will light Bin Full. All shredder
functions will stop. After the bin is emptied, place it back into the cabinet and close the
doors. The LED will light Power and resume normal function.
Care and Maintenance:
Feed Rollers
The eight black inlet belts should be cleaned
every time the shredder bin is full. In case the
paper is not drawn in completely, although the
feeding belts have been cleaned, the complete
feeding unit can be replaced. Please call
customer support for further instructions and
information.
Blade Lubrication
To keep your shredder running smoothly and
dispose of shreds quickly, use shredder lubricant
sheets. Apply lubricants after 30 minutes of
shredding or a minimum of twice per month.
Shredder bag will fit this model.
8